SICK Inductive proximity sensors IMP12 Series, Cylindrical threaded housing

SICK Inductive proximity sensors IMP12 Series, Cylindrical threaded housing Model Name IMP12-1B5NOVC0B Part No. 6050116 At a glance Pressure resistant up to 500 bar Expected service life of up to 1 million pressure cycles Sensing range of 1.5 mm flush IP 68 Stainless steel housing with active surface made from stable high-performance ceramic State-of-the-art ASIC technology from SICK Gas-tight at the sensor face 3 and 4-wire versions Your benefits Reduced maintenance costs Extremely resilient and durable Up to 50 times longer service life compared to conventional sensors under pressure cycles Simple compensation of cylinder tolerances Simple integration due to small design Controlled piston deceleration Increased piston service life due to collision prevention at the end of the work cycle Features Housing: Cylindrical Thread size: M12 x 1 Sensing range Sn: 1.5 mm Assured sensing range Sa: 1.2 mm Pressure resistance: d 500 bar Installation type: Flush Switching frequency: 600 Hz Output type: NPN Output function: NC Electrical wiring: DC 3-wire Enclosure rating: IP 68 1) Connection type: Connector M12, 4-pin 1) Sensing face Mechanics/ electronics Supply voltage: 10 V DC ... 30 V DC Vacuum resistance: 10-8Torr 1) Ripple: d 20 % 2) Voltage drop: d 2 V 3) Current consumption: d 10 mA 4) Time delay before availability: d 50 ms Hysteresis: 1 % ... 15 % 5) Repeatability: d 7 % 6) 7) Temperature drift ( of Sr) : d 15 % EMC: According to EN 60947-5-2 Output current Ia: d 200 mA Short-circuit protection: Reverse polarity protection: Power-up pulse protection: - Shock/ vibration: 30 g, 11 ms / 10 ... 55 Hz, 1 mm Ambient operating temperature: -25 ° C ... + 80 ° C Housing material: Stainless steel, V2A Housing cap material: Ceramics, ZrO2 Size support ring: 10 mm x 5.9 mm x 1 mm Size sealing ring: 5.3 mm x 2.4 mm Material sealing ring: FPM Housing length: 56 mm Thread length: 28 mm Tightening torque, max.: d 40 Nm 1) Front 2) Of VS 3) With Ia = 200 mA 4) Without load 5) Typ. 8% 6) 7) Reduction factors Note: The values are reference values which may vary Carbon steel St37 ( Fe) : 1 Stainless steel ( V2A, 304) : Ca. 0.75 Copper ( Cu) : Ca. 0.12 Aluminum ( Al) : Ca. 0.2 Brass ( Br) : Ca. 0.34 Installation note Remark: Associated graphic see " Installation"